D-Link DGS-3130 Emulator - Page 535
snmp-server enable traps loopback-detection
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 535 highlights
Parameters shutdown none DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies to shut down the port in the port-based mode or block traffic on the specific VLAN in the VLAN-based mode when a loop has been detected. Specifies not to shut down the port in the port-based mode or block traffic on the specific VLAN in the VLAN-based mode when a loop has been detected. Default By default, this mode is shutdown. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the loop-detection mode. Example This example shows how to configure the loop-detection mode. Switch# configure terminal Switch(config)# loopback-detection action none Switch(config)# 49-7 snmp-server enable traps loopback-detection This command is used to enable the sending of SNMP notifications for loopback detection. Use the no form of this command to revert to the default setting. snmp-server enable traps loopback-detection no snmp-server enable traps loopback-detection Parameters None. Default By default, this feature is disabled. Command Mode Global Configuration Mode. Command Default Level Level: 12. 531