D-Link DGS-3130 Emulator - Page 332
State, Enabled, Disabled, ACL Match, Static ACL, ACL logging, Permit, DHCP Logging
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 332 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch#show ip arp inspection Source MAC Validation : Enabled Destination MAC Validation: Disabled IP Address Validation : Disabled VLAN State ACL Match Static ACL 10 Disabled static-arp-list No VLAN ACL Logging DHCP Logging 10 Deny Deny Switch# Display Parameters VLAN State ACL Match Static ACL ACL logging DHCP Logging The VLAN ID that enables ARP inspection. The configuration state of ARP inspection. Enabled: ARP inspection is enabled. Disabled: ARP inspection is enabled. The name of ARP ACL that is specified. The configuration of the static ACL. Yes: Static ARP ACL is configured. No: Static ARP ACL is not configured. The state of logging for packets dropped or permitted based on ACL matches. None: ACL-matched packets are not logged. Permit: Logging when packets are permitted by the configured ACL. Deny: Logging when packets are dropped by the configured ACL. All: ACL-matched packets are always logged. The state of logging for packets dropped or permitted based on DHCP bindings. None: Prevent logging when packets are dropped or permitted by the DHCP bindings. Permit: Logging when packets are permitted by the DHCP bindings. Deny: Logging when packets are dropped by the DHCP bindings. All: Logging when packets are dropped or permitted by the DHCP bindings. Example This example shows how to display the trust state of ethernet 1/0/10. Switch#show ip arp inspection interfaces ethernet 1/0/10 Interface Trust State Rate(pps) Burst Interval eth1/0/10 trusted None 1 Total Entries: 1 Switch# This example shows how to display the trust state of interfaces on the Switch. 328