D-Link DGS-3130 Emulator - Page 707
ip rip v2-broadcast, network
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 707 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 68-8 ip rip v2-broadcast This command is used to enable the sending of version 2 RIP update packets as broadcast packets instead of multicast packets. Use the no form of this command to revert to the default setting. ip rip v2-broadcast no ip rip v2-broadcast Parameters None. Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline RIP version 2 improves version 1 by sending multicast packets instead of broadcast packets in order to reduce the load on unnecessary hosts on the LAN to process the broadcast packet. Use this command to broadcast RIP version 2 updates to devices that do not listen to multicast packets. If enabled, version 2 packets will be sent to the IP broadcast address instead of the IP multicast address 224.0.0.9. Example This example shows how to configure the interface VLAN 100 to broadcast version 2 RIP packets. Switch# configure terminal Switch(config)# interface vlan 100 Switch(config-if)# ip rip send version 2 Switch(config-if)# ip rip v2-broadcast Switch(config-if)# 68-9 network This command is used to specify a network as one that runs RIP. Use the no form of this command to remove an entry. network NETWORK-PREFIX no network NETWORK-PREFIX Parameters NETWORK-PREFIX Specifies the subnet prefix of the network. 703