D-Link DGS-3130 Emulator - Page 811

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide spanning-tree link-type {point-to-point | shared} no spanning-tree link-type Parameters point-to-point shared Specifies that the port's link type is point-to-point. Specifies that the port's link type is a shared media connection. Default The link type is automatically derived from the duplex setting unless explicitly configuring the link type. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline A full-duplex port is considered to have a point-to-point connection; on the opposite, a half-duplex port is considered to have a shared connection .The port can't transit into forwarding state rapidly by setting link type to shared-media. Hence, auto-determined of link-type by the STP module is recommended. This configuration will take effect for all the spanning-tree modes. Example This example shows how to configure the link type to point-to-point for port Ethernet 1/0/7. Switch# configure terminal Switch(config)# interface ethernet 1/0/7 Switch(config-if)# spanning-tree link-type point-to-point Switch(config-if)# 78-20 spanning-tree mode This command is used to configure the STP mode. Use the no form of this command to revert to the default setting. spanning-tree mode {mstp | rstp |stp} no spanning-tree mode Parameters mstp rstp stp Specifies the Multiple Spanning Tree Protocol (MSTP). Specifies the Rapid Spanning Tree Protocol (RSTP). Specifies the Spanning Tree Protocol (IEEE 802.1D Compatible) Default By default, this mode is RSTP. 807