D-Link DGS-3130 Emulator - Page 534
loopback-detection action
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 534 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch#sh loopback-detection Loop Detection Detection Mode LBD enabled VLAN Interval Action Mode Address Type Function Version : Enabled : port-based : all VLANs : 20 seconds : Shutdown : Multicast : v4.07 Interface State Result Time Left (sec) eth1/0/1 Enabled Normal - eth1/0/2 Disabled Normal - eth1/0/3 Disabled Normal - eth1/0/4 Disabled Normal - eth1/0/5 Disabled Normal - eth1/0/6 Disabled Normal - eth1/0/7 Disabled Normal - eth1/0/8 Disabled Normal - eth1/0/9 Disabled Normal - eth1/0/10 Disabled Normal - eth1/0/11 Disabled Normal - eth1/0/12 Disabled Normal - eth1/0/13 Disabled Normal - CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All This example shows how to display the loopback detection status for port 1/0/1. Switch#show loopback-detection interface ethernet 1/0/1 Interface eth1/0/1 State -------Enabled Result Normal Time Left (sec Switch# Display Parameters Interface State Result Time Left Indicates the port that has loopback detection enabled. Indicates the port state. Indicates whether a loop is detected. The remaining time before being auto-recovered. 49-6 loopback-detection action This command is used to configure the loopback-detection mode. Use the no form of this command to revert to the default setting. loopback-detection action {shutdown | none} no loopback-detection action 530