D-Link DGS-3130 Emulator - Page 832
show supervlan
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 832 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode VLAN Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is only applicable on a sub-VLAN and is used to configure the IP address range of a sub-VLAN. Configuring IP address range(s) of a sub-VLAN can reduce the overhead when the Switch is the ARP proxy between sub-VLANs. The wrong configuration of IP address ranges may cause IP traffic not to be routed correctly. A sub-VLAN can have one or more IP address ranges. The configured IP address range should not overlap with the existed address ranges of other sub-VLANs and must belong to the subnet of the super VLAN interface. Within a sub-VLAN, the configured IP address range will be merged into other range(s) if applicable. Example This example shows how to configure the IP address range of the sub-VLAN 5. Switch# configure terminal Switch(config)# vlan 5 Switch(config-vlan)# subvlan-address-range 192.168.10.1 192.168.10.50 Switch(config-vlan)# 81-4 show supervlan This command is used to display the configuration of the super VLAN and its sub-VLANs. show supervlan [VLAN-ID [, | -]] Parameters VLAN-ID , - (Optional) Specifies the ID of the super VLAN to be displayed. (Optional) Specifies a series of VLANs, or separate a range of VLANs from a previous range. No space is allowed before and after the comma. (Optional) Specifies a range of VLANs. No space is allowed before and after the hyphen. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline Use this command to display the configuration of the super VLAN and its sub-VLANs. 828
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/832.png)