D-Link DGS-3130 Emulator - Page 720
passive-interface
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 720 highlights
Parameters DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide PROTOCOL metric METRIC-VALUE Specifies the protocol whose routes are to be redistributed. It can be one of the following keywords: connected and static. The static keyword means to redistribute IP static routes. The connected keyword refers to routes that are established automatically by virtue of configuring IP address on an interface. (Optional) Specifies the value to be used as the metric for the redistributed routes. The range is from 0 to 16. Default By default, this option is disabled. Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline If the metric option is not specified or specified as 0, the following rules are applied: The metric of the redistributed static route or connected route will be 1, if the metric option is not specified, or is specified as 0. The metric of the redistributed route from other protocols to RIP process will be determined by the default metric command if the metric option is not specified. The metric of the redistributed route from other protocols to RIP process will be 1 if the metric option is specified as 0. If the default metric is not specified, then the original metric from the redistributed protocol will be transparently carried through. Example This example shows how to configure the OSPF routes to be redistributed into an RIP domain. The metric will be remapped to 10. Switch# configure terminal Switch(config)# ipv6 router rip Switch(config-rtr)# redistribute ospf metric 10 Switch(config-rtr)# 69-9 passive-interface This command is used to disable the sending of the routing updates on an interface. Use the no form of this command to revert to the default setting. passive-interface {default | INTERFACE-ID} no passive-interface {default | INTERFACE-ID} Parameters default INTERFACE-ID Specifies the global default passive state for the interface. Specifies an interface to be used. 716
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/720.png)