D-Link DGS-3130 Emulator - Page 864
clear attack-logging
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 864 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide show attack-logging unit UNIT-ID [index INDEX] Parameters UNIT-ID index INDEX Specifies the unit on which the attack log messages will be displayed. Specifies the list of index numbers of the entries that need to be displayed. If no index is specified, all entries in the attack log DB will be displayed. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline Use this command to display the attack log messages. The attack log message refers to log messages driven by modules such as DOS and the port-security module. This type of log message may generate a large amount of messages and quickly cause the system to run out of system log storage. Therefore, for this type of log messages only the first log that is generated each minute can be stored in the system log, with the rest of them being stored in a separate table named attack log. Example This example shows how to display the first attack log entry. Switch# show attack-logging index 1 Attack log messages: 1 2015-03-24 15:00:14 CRIT(2) Land attack is blocked from (IP: 10.72.24.1 Port: 7) Switch# 85-11 clear attack-logging This command is used to delete the attack log. clear attack-logging {unit UNIT-ID | all} Parameters unit UNIT-ID all Specifies the unit on which the attack log messages will be cleared. Specifies to clear all attack log entries. Default None. 860