D-Link DGS-3130 Emulator - Page 347
ethernet oam remote-loopback
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 347 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Default The Ethernet OAM critical event will be notified by default. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command used to configure the capability of the critical event. If the capability for a critical event is disabled, the port will never send out OAM PDUs with critical event bit set when an unspecified critical event has occurred. Example This example shows how to enable notifying critical events on ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# ethernet oam remote-failure critical-event Switch(config-if)# 32-9 ethernet oam remote-loopback This command is used to set the action of the remote loopback on the specified port. ethernet oam remote-loopback {start | stop} interface INTERFACE-ID [, | -] Parameters start stop interface INTERFACE-ID , - Specifies to request the peer to change to the remote loopback mode. Specifies to request the peer to change to the normal operation mode. Specifies the ID of an interface to do the remote loopback action. The allowed interfaces only include physical ports. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Default None. Command Mode Privileged EXEC Mode. Command Default Level Level: 12. 343