D-Link DGS-3130 Emulator - Page 68

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# show vlan filter VLAN Map aa Configured on VLANs: 5-127,221-333 VLAN Map bb Configured on VLANs: 1111-1222 Switch# Switch# show vlan filter vlan 5 VLAN ID 5 VLAN Access Map: aa Switch# 4-22 vlan access-map This command is used to create a sub-map of a VLAN access map and enter the VLAN access-map sub-map configure mode. Use the no form of this command to delete an access-map or its sub-map. vlan access-map MAP-NAME [SEQUENCE-NUM] no vlan access-map MAP-NAME [SEQUENCE-NUM] Parameters MAP-NAME SEQUENCE-NUM Specifies the name of the VLAN access map to be configured. The name can be up to 32 characters. (Optional) Specifies the sequence number of the sub-map. The valid range is from 1 to 65535. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline A VLAN access map can contain multiple sub-maps. For each sub-map, one access list (IP access list, IPv6 access list or MAC access list) can be specified and one action can be specified. After a VLAN access map is created, the user can use the vlan filter command to apply the access map to VLAN(s). A sequence number will be assigned automatically if the user does not assign it manually, and the automatically assigned sequence number starts from 10, and increase 10 per new entry. The packet that matches the sub-map (that is packet permitted by the associated access-list) will take the action specified for the sub-map. No further check against the next sub-maps is done. If the packet does not match a submap, then the next sub-map will be checked. Using the no form of this command without specify sequence numbers, will delete all sub-map information of the specified access-map. 64