D-Link DGS-3130 Emulator - Page 578
access-group, range
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 578 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 53-8 access-group This command is used to bind an access group profile to a multicast VLAN. Use the no form of this command to remove the binding. access-group PROFILE-NAME no access-group PROFILE-NAME Parameters PROFILE-NAME Specifies the name of the profile. Default None. Command Mode Multicast VLAN Configuration Mode. Command Default Level Level: 12. Usage Guideline A single multicast VLAN can be bound with more than one profile as its real group range. Group ranges cannot overlap with multicast VLANs. If a port is a member of more than one multicast VLAN, the group-profile bound to the multicast VLAN will decide which multicast VLAN can learn the group. If a port is member of a single multicast VLAN and an access group is configured for the multicast VLAN, only those groups permitted by the access group are learned with the multicast VLAN. If there is no access group configured, then all multicast groups will be learned with the multicast VLAN. Example This example shows how to bind the profile "mv_profile1" to multicast VLAN 100. Switch#configure terminal Switch(config)#mvlan vlan 100 Switch(config-mvlan)#access-group mv_profile1 Switch(config-mvlan)# 53-9 range This command is used to configure the multicast address range for a multicast VLAN profile. Use the no form of this command to remove a range. range {IPV4-ADDRESS-START [IPV4-ADDRESS-END] | IPV6-ADDRESS-START [IPV6-ADDRESS-END]} no range {IPV4-ADDRESS-START [IPV4-ADDRESS-END] | IPV6-ADDRESS-START [IPV6-ADDRESS-END]} Parameters IPV4-ADDRESS-START IPV4-ADDRESS-END Specifies the IPv4 multicast start address in the range. Specifies the IPv4 multicast end address in the range. 574