D-Link DGS-3130 Emulator - Page 125
ip arp elevation
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Parameters None. DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to enable the local proxy ARP function on an interface. This command is used in the primary VLAN of a private VLAN domain to enable routing of packets among secondary VLANs or isolated ports within the domain. The command only take effects when ip proxy arp is enabled. Example This example shows how to enable local proxy ARP on VLAN 100. Switch# configure terminal Switch(config)# interface vlan 100 Switch(config-if)# ip local-proxy-arp Switch(config-if)# 9-7 ip arp elevation This command is used to assign a higher priority to all ARP packets to this switch than other ARP packets. ip arp elevation no ip arp elevation Parameters None. Default By default, all ARP packets have the same priority. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to assign a higher priority to all ARP packets to this switch than other ARP packets. 121