D-Link DGS-3130 Emulator - Page 576
replace-source-ip
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 576 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode Multicast VLAN Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to specify the name of a multicast VLAN. Example This example shows how to configure the multicast VLAN name of multicast VLAN 100 to "ip-tv". Switch# configure terminal Switch(config)# mvlan vlan 100 Switch(config-mvlan)# name ip-tv Switch(config-mvlan)# 53-6 replace-source-ip This command is used to replace the source IP address in the reporting IGMP/MLD packet sent to uplink ports. Use the no form of this command to cancel the replacement. replace-source-ip {ipv4 IPV4-ADDRESS | ipv6 IPV6-ADDRESS} from { source | receiver | both} no replace-source-ip {ipv4 | ipv6} Parameters ipv4 IPV4-ADDRESS ipv6 IPV6-ADDRESS source receiver both Specifies the source IP address to be substituted for the source IP address in the reporting IGMP control packet to uplink ports. Specifies the source IP address to be substituted for the source IP address in the reporting MLD control packet to uplink ports. Specifies to replace the source IP address of the IGMP or MLD report/leave/done packet received on any multicast VLAN source port with the specified IPv4 or IPv6 address. Specifies to replace the source IP address of the IGMP or MLD report/leave/done packet received on any multicast VLAN receiver port with the specified IPv4 or IPv6 address. Specifies to replace the source IP address of the IGMP or MLD report/leave/done packet received on any port in the multicast VLAN with the specified IPv4 or IPv6 address. Default None. Command Mode Multicast VLAN Configuration Mode. Command Default Level Level: 12. 572