D-Link DGS-3130 Emulator - Page 536
loopback-detection address-type
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 536 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline This command is used to enable the sending of SNMP notifications for loopback detection. Use the no command to return to the default settings. Example This example shows how to enable the sending of SNMP notifications for loopback detection. Switch# configure terminal Switch(config)# snmp-server enable traps loopback-detection Switch(config)# 49-8 loopback-detection address-type This command is used to configure the DA type of loopback-detection packets. Use the no form of this command to revert to the default setting. loopback-detection address-type {multicast | broadcast} no loopback-detection address-type Parameters multicast broadcast Specifies to only send multicast LBD packets. The DA is CF-00-00-00-00-00. Specifies to only send broadcast LBD packets. The DA is FF-FF-FF-FF-FF-FF. Default By default, this mode is multicast. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the DA type of loopback-detection packets. Example This example shows how to configure the DA type of loopback-detection packets to broadcast. Switch#configure terminal Switch(config)#loopback-detection address-type broadcast Switch(config)# 532
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/536.png)