D-Link DGS-3130 Emulator - Page 603

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 56-5 poe power-inline This command is used to configure the power management mode for the Power over Ethernet (PoE) ports. Use the no form of this command to remove the time range profile association or restore the mode to default settings. poe power-inline {auto [max MAX-WATTAGE] [time-range PROFILE-NAME] | never} no poe power-inline [auto {max | time-range} Parameters auto max MAX-WATTAGE time-range PROFILENAME never Enable auto-detection of PDs and provision power to the PD. (Optional) Set the max wattage of power that can be provisioned to the auto-detected PD. If not specified, then the class of the PD auto determines the maximum wattage which can be provisioned. The valid range for max wattage is 1000 mW to n mW. (Optional) Specifies the name of time-range profile to delineate the activation period. Disable supplying power to PD connected to the port. Default By default, this option is set in auto mode. Command Mode Interface configuration mode. Command Default Level Level: 12. Usage Guideline This command is supported only on PoE-capable ports. When the port is set to auto mode, the port will automatically detect the PD and provision power to the PD. The user can explicitly specify a max wattage value which can be provisioned to the port. If the user doesn't specify the max wattage value, then the class of the PD auto determines the maximum wattage which can be provisioned. The PD will not be provisioned if it requests more wattage than the max wattage which is determined. The user can specify time range with a port. Once a PoE port is associated with a time-range profile, it will only be activated during the time frame specified in the profile. That is, the PD will not get powered during timeframe out of the specified time range. The user can pre-allocate power budget to the port by configuring the port to work in static mode. The power budget is allocated to the port even though there is no PD connected to the port. If the maximum wattage is specified, the specified number of wattage is pre-allocated. When the command no poe power-inline is issued, the power management mode will be reset to default setting. The specified time range profile does not need to exist to configure the command. If the time range profile does not exist, the command acts as if time range is not specified. Example This example shows how to enable PD detection and power up PoE interface eth3/0/1 automatically. Switch(config)# interface range eth3/0/1 Switch(config-if)# poe power-inline auto This example shows how to configure a PoE port on port eth3/0/1, allows powered device under 5000mW. 599