D-Link DGS-3130 Emulator - Page 887
switchport hybrid native vlan, 11 switchport mode
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 887 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 89-10 switchport hybrid native vlan This command is used to specify the native VLAN ID of a hybrid port. Use the no form of this command to revert to the default setting. switchport hybrid native vlan VLAN-ID no switchport hybrid native vlan Parameters VLAN-ID Specifies the native VLAN of a hybrid port. Default By default, the native VLAN of a hybrid port is VLAN 1. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline When configuring the hybrid port join to its native VLAN, use the switchport hybrid allowed vlan command to add the native VLAN into its allowed VLAN. The specified VLAN does not need to exist to apply the command. The command takes effect when the interface is set to hybrid mode. Example This example shows how to configure ethernet 1/0/1 to become a hybrid interface and configure the PVID to 20. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# switchport mode hybrid Switch(config-if)# switchport hybrid allowed vlan add untagged 1000,20 Switch(config-if)# switchport hybrid native vlan 20 Switch(config-if)# 89-11 switchport mode This command is used to specify the VLAN mode for the port. Use the no form of this command to revert to the default setting. switchport mode {access | hybrid | trunk | dot1q-tunnel} no switchport mode Parameters access hybrid trunk Specifies the port as an access port. Specifies the port as a hybrid port. Specifies the port as a trunk port. 883