D-Link DGS-3130 Emulator - Page 30

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide in Specifies to enable in direction control for the port. Default By default, the bidirectional mode is used. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is only available for physical port interface configuration. If the port control is set to forceauthorized, then the port is not controlled in both directions. If the port control is set to auto, then the access to the port for the controlled direction needs to be authenticated. If the port control is set to force-unauthorized, then the access to the port for the controlled direction is blocked. Suppose that port control is set to auto. If the control direction is set to both, then the port can receive and transmit EAPOL packets only. All user traffic is blocked before authentication. If the control direction is set to in, then in addition to receiving and transmitting EAPOL packets, the port can transmit user traffic but not receive user traffic before authentication. Example This example shows how to configure the controlled direction of the traffic through Ethernet 1/0/1 as unidirectional. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# dot1x control-direction in Switch(config-if)# 3-3 dot1x default This command is used to revert the IEEE 802.1X parameters on a specific port to their default settings. dot1x default Parameters None. Default IEEE 802.1X authentication is disabled. Control direction is bidirectional mode. Port control is auto. Forward PDU on port is disabled. Maximum request is 2 times. Server timer is 30 seconds. Supplicant timer is 30 seconds. Transmit interval is 30 seconds. 26