D-Link DGS-3130 Emulator - Page 600

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 56. Power over Ethernet (PoE) Commands 56-1 poe pd description This command is used to configure the description for the PD connected to the PoE port. Use no form of this command to clear the description. poe pd description TEXT no poe pd description Parameters TEXT String that describes the PD connected to a PoE interface. The maximum length is 32. Default None. Command Mode Interface configuration. Command Default Level Level: 12. Usage Guideline The command is available for physical port configuration and could be used to configure a description for the PD connected to the port. Example This example shows how to configure the PoE PD description on interface eth3/0/1. Switch(config)# interface eth3/0/1 Switch(config-if)# poe pd description For VOIP usage 56-2 poe pd legacy-support This command is used to enable support of legacy PD. Use no form of this command to disable it. poe pd legacy-support no poe pd legacy-support Parameters None. Default By default, this option is disabled. 596