D-Link DGS-3130 Emulator - Page 37

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide tx-period SECONDS Specifies the number of seconds that the Switch will wait for a response to an EAP-Request/Identity frame from the supplicant before retransmitting the request. The range is 1 to 65535 Default The server-timeout is 30 seconds. The supp-timeout is 30 seconds. The tx-period is 30 seconds. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is only available for physical port interface configuration. Example This example shows how to configure the server timeout value, supplicant timeout value, and the TX period on Ethernet port 1/0/1 to be 15, 15, and 10 seconds, respectively. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# dot1x timeout server-timeout 15 Switch(config-if)# dot1x timeout supp-timeout 15 Switch(config-if)# dot1x timeout tx-period 10 Switch(config-if)# 3-12 show dot1x This command is used to display the IEEE 802.1X global configuration or interface configuration. show dot1x [interface INTERFACE-ID [, | -]] Parameters interface INTERFACE-ID , - (Optional) Specifies to display the dot1x configuration on the specified interface or range of interfaces. If not specified, the global configuration will be displayed. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Default None. 33