D-Link DGS-3130 Emulator - Page 585
ipv6 nd inspection attach-policy
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 585 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide not performed. When performing NS/NA inspection, the message will be verified against the dynamic binding table learned from the ND protocol or from the DHCP. Example This example shows how to create a ND policy named "policy1" and configures the device's role to host. Switch# configure terminal Switch(config)# ipv6 nd inspection policy policy1 Switch(config-nd-inspection)# device-role host Switch(config-nd-inspection)# 54-4 ipv6 nd inspection attach-policy This command is used to apply an ND inspection policy on the specified interface. Use the no form of this command to remove the ND inspection policy. ipv6 nd inspection attach-policy [POLICY-NAME] no ipv6 nd inspection attach-policy Parameters POLICY-NAME (Optional) Specifies the ND Inspection policy name. Default By default, ND inspection policy is not applied. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is available for physical port and port channel configuration. The command is used to apply the ND Inspection policy on a specified interface. If no policy-name is specified, the behavior of the default policy is as follows: NS/NA messages are inspected. Layer 2 header source MAC address validations are disabled. Example This example shows how to apply ND inspection policy called "policy1" on ethernet 1/0/3. 581