D-Link DGS-3130 Emulator - Page 975
Appendix D - RADIUS Attributes Assignment
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 975 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Appendix D - RADIUS Attributes Assignment The RADIUS Attributes Assignment on the DGS-3130 is used in the following modules: Console, Telnet, SSH, Web, 802.1X, MAC-based Access Control, and WAC. The description that follows explains the following RADIUS Attributes Assignment types: Privilege Level Ingress/Egress Bandwidth 802.1p Default Priority VLAN ACL To assign the Privilege Level by the RADIUS server, the proper parameters should be configured on the RADIUS server. The table below shows the parameters for the bandwidth. The parameters of the Vendor-Specific attributes are: Vendor-Specific Attribute Vendor-ID Vendor-Type Attribute-Specific Field Description Defines the vendor. Defines the attribute. Used to assign the privilege level of the user to operate the switch. Value 171 (DLINK) 1 Range (1-15) Usage Required Required Required If the user has configured the privilege level attribute of the RADIUS server (for example, level 15) and the Console, Telnet, SSH, and Web authentication is successful, the device will assign the privilege level (according to the RADIUS server) to this access user. However, if the user does not configure the privilege level attribute and authenticates successfully, the device will not assign any privilege level to the access user. If the privilege level is configured less than the minimum supported value or greater than the maximum supported value, the privilege level will be ignored. To assign the Ingress/Egress Bandwidth by the RADIUS server, the proper parameters should be configured on the RADIUS Server. The table below shows the parameters for bandwidth. The parameters of the Vendor-Specific attributes are: Vendor-Specific Attribute Vendor-ID Vendor-Type Attribute-Specific Field Description Defines the vendor. Defines the attribute. Used to assign the bandwidth of a port. Value 171 (DLINK) 2 (for ingress bandwidth) 3 (for egress bandwidth) Unit (Kbits) Usage Required Required Required If the user has configured the bandwidth attribute of the RADIUS server (for example, ingress bandwidth 1000Kbps) and 802.1X authentication is successful, the device will assign the bandwidth (according to the RADIUS server) to the port. However, if the user does not configure the bandwidth attribute and authenticates successfully, the device will not assign any bandwidth to the port. If the bandwidth attribute is configured on the RADIUS server with a value of "0", the effective bandwidth will be set "no_limited", and if the bandwidth is configured less than "0" or greater than maximum supported value, the bandwidth will be ignored. 971
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/975.png)