D-Link DGS-3130 Emulator - Page 85
terminal length
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to Telnet to the IP address 10.90.90.91 using the default port 23. The IP address, 10.90.90.91 is the DGS-3130-30TS management interface which allows a user to login. Switch# telnet 10.90.90.91 DGS-3130-30TS Gigabit Ethernet Switch Command Line Interface Firmware: Build 1.00.001 Copyright(C) 2017 D-Link Corporation. All rights reserved. Password required, but none set Switch# This example shows how to Telnet through port 23 to 10.90.90.91 and the connection failed. Try using port 3500 instead to login into the management interface. Switch#telnet 10.90.90.91 ERROR: Could not open a connection to host on server port 23. Switch# telnet 10.90.90.91 3500 DGS-3130-30TS Gigabit Ethernet Switch Command Line Interface Firmware: Build 1.00.001 Copyright(C) 2017 D-Link Corporation. All rights reserved. Password required, but none set Switch# 5-21 terminal length The command is used to configure the number of lines displayed on the screen. The terminal length command will only affect the current session. The terminal default length command will set the default value but it doesn't affect the current session. The newly created, saved session terminal length will use the default value. Use the no form of this command to revert to the default setting. terminal length NUMBER no terminal length terminal length default NUMBER no terminal length default Parameters NUMBER Specifies the number of lines to display on the screen. This value must be between 0 and 512.When the terminal length is 0, the display will not stop until it reaches the end of the display. 81