D-Link DGS-3130 Emulator - Page 841

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 83-2 flowcontrol This command is used to configure the flow control capability of the port interface. Use the no form of this command to revert to the default setting. flowcontrol {on | off} no flowcontrol Parameters on off Specifies to enable a port to send PAUSE frames or process PAUSE frames from remote ports. Specifies to disable the ability for a port to send or receive PAUSE frames. Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command can only assure that the flow control capability has been configured in the Switch software and not guarantee the actual hardware operation. The actual hardware operation may be different to the settings that have been configured on the Switch because the flow control capability is determined by both the local port/device and the device connected at the other end of the link, not just by the local device. If the speed is set to the forced mode, the final flow control setting will be determined by the configured flow control setting. If the speed is set to the auto mode, the final flow control setting will be based on the negotiated result between the local side setting and the partner side setting. The configured flow control setting here is the local side setting. This command does not work through Switches that are physically stacked. Example This example shows how to enable the flow control on ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# flowcontrol on Switch(config-if)# 83-3 mdix This command is used to configure the port Media-Dependent Interface Crossover (MDIX) state. Use the no form of this command to revert to the default setting. mdix {auto | normal | cross} no mdix 837