D-Link DGS-3130 Emulator - Page 696

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# ip access-list Strict-Control Switch(config-ip-acl)# permit 10.1.1.0 0.0.0.255 any Switch(config-ip-acl)# exit Switch(config)# route-map myPolicy permit 1 Switch(config-route-map)# match ip address Strict-Control Switch(config-route-map)# set ip next-hop 120.1.2.2 Switch(config-route-map)# exit Switch(config)# interface vlan 100 Switch(config-if)# ip policy route-map myPolicy Switch(config-if)# 66-10 set ip precedence This command is used to configure the precedence value in the IP header. Use the no form of this command to remove the setting. set ip precedence {NUMBER | NAME} no set ip precedence Parameters NUMBER NAME Specifies the number of the precedence value to use in the IP header. The following numbers represent the following names:  0 - Routine.  1 - Priority.  2 - Immediate.  3 - Flash.  4 - Flash-override.  5 - Critical.  6 - Internet.  7 - Network. Specifies the name of the precedence value to use in the IP header. Default None. Command Mode Route-map Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to set the precedence value in the IP header. This command only takes effect when policy routing involves the IPv4 packet. The precedence can be set using either a number or the corresponding name. 692