D-Link DGS-3130 Emulator - Page 635

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide distance default DISTANCE no distance default Parameters DISTANCE Specifies the administrative distance. The range is from 1 to 255. Default The default distance of a static default route is 1. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the distance is an integer from 1 to 255 representing the trust rating of the route. The route with a lower distance value is preferred over the route with a higher distance value. A route with the distance 255 will not be installed for routing of packets since it indicates that the route is not trusted. If the distance command is used without parameters, the specified distance becomes the default value for routes of the configured protocol. Example This example shows how to configure the static default route distance to be 150. Switch#configure terminal Switch(config)#distance default 150 Switch(config)# 62-3 distance static This command is used to define an administrative distance for static routes. Use the no form of this command to revert to the default setting. distance static DISTANCE no distance static Parameters DISTANCE Specifies the administrative distance. The range is from 1 to 255. Default The default distance of a static route is 60. Command Mode Global Configuration Mode. 631