D-Link DGS-3130 Emulator - Page 825
Storm Control Commands
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 825 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 80. Storm Control Commands 80-1 snmp-server enable traps storm-control This command is used to enable and configure the sending of SNMP notifications for storm control. Use the no form of this command to disable the sending of SNMP notifications. snmp-server enable traps storm-control [storm-occur] [storm-clear] no snmp-server enable traps storm-control [storm-occur] [storm-clear] Parameters storm-occur storm-clear (Optional) Specifies to send a notification when a storm event is detected. (Optional) Specifies to send a notification when a storm event is cleared. Default By default, this option is disabled. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline None. Example This example shows how to enable the sending of traps for storm control for both storm occurrences and clearances. Switch# configure terminal Switch(config)# snmp-server enable traps storm-control Switch(config)# 80-2 storm-control This command is used to configure the device to protect the device from broadcast, multicast, and DA unknown packet storm attacks. Use the no form of this command to revert to the default settings. storm-control {{broadcast | multicast | unicast} level {pps PPS-RISE [PPS-LOW] | kbps KBPS-RISE [KBPS-LOW] | LEVEL-RISE [LEVEL-LOW]} | action {shutdown | drop | none}} no storm-control {broadcast | multicast | unicast | action} Parameters broadcast multicast Specifies to set the broadcast rate limit. Specifies to set the multicast rate limit. 821