D-Link DGS-3130 Emulator - Page 35
dot1x re-authenticate
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# dot1x pae authenticator Switch(config-if)# This example shows how to disable IEEE 802.1X authentication on ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# no dot1x pae authenticator Switch(config-if)# 3-9 dot1x re-authenticate This command is used to re-authenticate a specific port or a specific MAC address. dot1x re-authenticate {interface INTERFACE-ID [, | -] | mac-address MAC-ADDRESS} Parameters interface INTERFACE-ID , - mac-address MACADDRESS Specifies the port to re-authenticate. Valid interfaces are physical ports. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Specifies the MAC address to re-authenticate. Default None. Command Mode Privileged EXEC Mode. Command Default Level Level: 12. Usage Guideline This command is used to re-authenticate a specific port or a specific MAC address. In the multi-host mode, specify an interface ID to re-authenticate a specific port. In the multi-auth mode, specify a MAC address to re-authenticate a specific MAC address. Example This example shows how to re-authenticate ethernet 1/0/1. Switch# dot1x re-authenticate interface ethernet 1/0/1 Switch# 31
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/35.png)