D-Link DGS-3130 Emulator - Page 626

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is available for physical port interface configuration. Example This example shows how to set the format of PPPoE circuit ID TAG on interface eth1/1's to device's MAC address. switch# configure terminal switch(config)#interface eth1/1 switch(config-if)# pppoe circuit-id-insert format mac 60-4 show pppoe circuit-id-insert This command is used to show the setting of PPPoE circuit ID insertion. show pppoe circuit-idinsert [ interface INTERFACE-ID [, | - ] ] Parameters interface INTERFACE-ID , - (Optional) Displays the configuration of PPPoE circuit ID insertion for a specified interface or range of interfaces. (Optional) Specifies an interface range by delimiting a list of interface IDs with ','. No space is allowed before and after the comma. (Optional) Specifies an interface range by delimiting the start and the ending interface numbers with '-'. No space is allowed before and after the hyphen. Default None. Command Mode EXE mode or any configuration mode. Command Default Level Level: 1. Usage Guideline The command can be used to display the setting of PPPoE circuit ID insertion. If this command is issued without interface keyword, the global setting of PPPoE circuit ID insertion will be displayed, otherwise, the setting of PPPoE circuit ID insertion on specified interface(s) will be displayed. Example The example shows how to display the global setting of PPPoE circuit ID insertion. 622