D-Link DGS-3130 Emulator - Page 911

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline In preempt mode, a router will take over the master role if it has a better priority than the current master. In non-preempt mode, the master will not be preempted unless the incoming router is the IP address owner of the virtual router. Example This example shows how to configure the router for VRRP group 7 to preempt the current master router when its priority is higher than that of the current master router. Switch# configure terminal Switch(config)# interface vlan 1 Switch(config-if)# vrrp 7 preempt Switch(config-if)# 91-8 vrrp shutdown This command is used to disable a virtual router on an interface. Use the no form of this command to revert to the default setting. vrrp VRID shutdown no vrrp VRID shutdown Parameters VRID Specifies the virtual router identifier that identifies the VRRP group. The valid range is from 1 to 255. Default By default, a virtual router is enabled after being created. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Avoid the common mistake of shutting down the IP address owner router before shutting down other non-owner routers. Example This example shows how to disable one VRRP VRID 1 on interface VLAN 1 while retaining the VRRP VRID 2. 907