D-Link DGS-3130 Emulator - Page 817
dot1d, dot1ad
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 817 highlights
Parameters dot1d dot1ad DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies to use the Customer Bridge Group Address (01-80-C2-00-00-00) as the destination address of the STP BPDU. Specifies to use Provider Bridge Group Address (01-80-C2-00-00-08) as the destination address of the STP BPDU. Default By default, the Customer Bridge Group Address is used as the destination address of the STP BPDU. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Generally, the Customer Bridge Group Address is used as the destination address of the STP BPDU. This command is used to designate the destination address of the STP BPDU in the service provider site. It will only take effect on the VLAN trunk ports, which behave as the NNI ports in the service provider site. This configuration will take effect for all the spanning-tree modes. Example This example shows how to configure using the dot1ad address as the destination address of the BPDU on the VLAN trunk port. Switch# configure terminal Switch(config)# spanning-tree nni-bpdu-address dot1ad Switch(config)# 813