D-Link DGS-3130 Emulator - Page 563

Parameters DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide IPV6-ADDRESS interface INTERFACE-ID , - Specifies an IPv6 multicast group address. Specifies the interfaces to be used. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Default No static-group is configured. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is only available for VLAN interface configuration. This command applies to MLD snooping on a VLAN interface to statically add group membership entries and/or source records. The ipv6 mld snooping static-group command allows the user to create an MLD snooping static group in case that the attached host does not support the MLD protocol. Example This example shows how to statically add group and/or source records for MLD snooping. Switch# configure terminal Switch(config)# vlan 1 Switch(config-vlan)# ipv6 mld snooping static-group FF02::12:03 interface ethernet 1/0/5 Switch(config-vlan)# 52-18 ipv6 mld snooping suppression-time This command is used to configure the time for suppressing duplicate MLD reports or leaves. Use the no form of this command to revert to the default setting. ipv6 mld snooping suppression-time SECONDS no ipv6 mld snooping suppression-time Parameters SECONDS Specifies to configure the time for suppressing duplicates MLD reports. The range is 1 to 300. Default By default, this value is 10 seconds. 559