D-Link DGS-3130 Emulator - Page 375
erps force switch ring_port, erps manual switch ring_port
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 375 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline Use this command to indicate that the ring is an open or a closed ring. This command is used in ERPSv2 only. Example This example shows how to configure the interconnect node "ring2 "as a sub-ring: Switch#configure terminal Switch(config)#ethernet ring g8032 ring2 Switch(config-erps-ring)#ring_type sub-ring Switch(config-erps-ring)# 33-21 erps force switch ring_port This command is used to block an ERPS instance port. erps force switch ring_port {port0 | port1} Parameters port0 port1 Specifies that port0 will be blocked. Specifies that port1 will be blocked. Default None. Command Mode ERPS Instance Configuration Mode. Command Default Level Level: 12. Usage Guideline This command forcibly blocks an instance port immediately after force is configured, irrespective of whether link failures have occurred. This command is used in ERPSv2 only. Example This example shows how to force the major ring, instance 1, port0 into blocking. Switch#configure terminal Switch(config)#ethernet ring g8032 major-ring Switch(config-erps-ring)#instance 1 Switch(config-erps-ring-instance)#erps force switch ring_port port0 Switch(config-erps-ring-instance)# 33-22 erps manual switch ring_port This command is used to block an ERPS instance port. 371