D-Link DGS-3130 Emulator - Page 722

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch#show ipv6 rip IPv6 RIP process, port 521, multicast-group FF02::9 Administrative distance is 71 Maximum paths is 16 Updates every 30 seconds, expire after 180 seconds Garbage collect after 120 seconds Split horizon is on; poison reverse is on Periodic updates 6, trigger updates 1 Interfaces: vlan 1 vlan 11 (passive) Redistribution: Redistributing static with metric 10 Switch# 69-11 split-horizon This command is used to enable the split-horizon option for an IPv6 RIP process. Use the no form of this command to disable the split-horizon option. split-horizon no split-horizon Parameters None. Default By default, this option is enabled. Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to enable split horizon mechanism in the IPv6 RIP routing update. When split horizon is enabled, the routes learned from an interface will be not advertised out to the same interface. Example This example shows how to disable split-horizon for IPv6 RIP. Switch# configure terminal Switch(config)# ipv6 router rip Switch(config-rtr)# no split-horizon Switch(config-rtr)# 718