D-Link DGS-3130 Emulator - Page 50

Parameters extended NAME DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide (Optional) Specifies that the IPv6 access list is the extended IPv6 access list, and more fields can be chosen for the filter. If the parameter is not specified, the IPv6 access list is the standard IPv6 access list. Specifies the name of the IPv6 access list to be configured. The maximum length is 32 characters. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline The name must be unique among all access lists. The characters used in the name are case sensitive. The biggest unused number in the range of the IPv6 access list numbers will be assigned automatically. Example This example shows how to configure an IPv6 extended access list, named ip6-control. Switch# configure terminal Switch(config)# ipv6 access-list extended ip6-control Switch(config-ipv6-ext-acl)# permit tcp any 2002:f03::1/16 Switch(config-ipv6-ext-acl)# This example shows how to configure an IPv6 standard access list, named ip6-std-control. Switch# configure terminal Switch(config)# ipv6 access-list ip6-std-control Switch(config-ipv6-acl)# permit any fe80::101:1/54 Switch(config-ipv6-acl)# 4-9 mac access-group This command is used to specify a MAC access list to be applied to an interface. Use the no form of this command to remove the access group control from the interface. mac access-group {NAME} [in | out] no mac access-group [NAME] [in | out] Parameters NAME in Specifies the name of the MAC access list to be applied. (Optional) Specifies that the MAC access list will be applied to check in the ingress direction. If direction is not specified, in is used. 46