D-Link DGS-3130 Emulator - Page 243
ip dhcp snooping station-move deny
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 243 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide ip dhcp snooping limit rate {VALUE | no-limit} no ip dhcp snooping limit rate Parameters VALUE no-limit Specifies the number of DHCP messages that can be processed per second. The valid range is from 1 to 300. Specifies no limitation on the rate. Default By default, this option is no-limit. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline When the rate of the DHCP packet exceeds the limitation, the port will be changed to the error disable state. Example This example shows how to configure number of DHCP messages that a switch can receive per second on port 1/0/3. Switch# configure terminal Switch(config)# interface ethernet 1/0/3 Switch(config-if)# ip dhcp snooping limit rate 100 Switch(config-if)# 21-11 ip dhcp snooping station-move deny This command is used to disable the DHCP snooping station move state. Use the no form of this command to enable the DHCP snooping roaming state. ip dhcp snooping station-move deny no ip dhcp snooping station-move deny Parameters None. Default By default, this option is enabled. Command Mode Global Configuration Mode. 239