D-Link DGS-3130 Emulator - Page 876

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 88. Traffic Segmentation Commands 88-1 show traffic-segmentation forward This command is used to display the traffic segmentation for some ports or all ports. show traffic-segmentation forward [interface INTERFACE-ID [, | -]] Parameters interface INTERFACE-ID , - (Optional) Specifies the interfaces to be displayed. The acceptable interface will be physical port or port channel. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline If no optional parameter is specified, the traffic segmentation configuration for all ports will be displayed. Example This example shows how to display the configuration of traffic segmentation for ethernet 1/0/1. Switch#show traffic-segmentation forward interface ethernet 1/0/1 Interface eth1/0/1 Forwarding Domain eth1/0/3-1/0/6 Total Entries: 1 Switch# 88-2 traffic-segmentation forward This command is used to restrict the Layer 2 packet forwarding domain of packets received by the configured port. Use the no form of this command to remove the specification of forwarding domain. traffic-segmentation forward interface INTERFACE-ID [, | -] no traffic-segmentation forward interface INTERFACE-ID [, | -] 872