D-Link DGS-3130 Emulator - Page 639

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide ip route ecmp advance-control mode {VALUE1 | VALUE2 | VALUE3 | VALUE4 } no ip route ecmp advance-control mode Parameters VALUE1 ... VALUE4 Specifies the number of ECMP or multipath route and the number of next-hop of each ECMP or multipath route to be changed according to the specified value. The value is 512, 256, 128 and 64. Default By default, the value is 128. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to enlarge or reduce the number of ECMP or multipath route. Example This example shows how to configure the number of ECMP or multipath route to 512. Switch#configure terminal Switch(config)#ip route ecmp advance-control mode 512 WARNING: The command does not take effect until after the next reboot. Switch(config)# 62-8 ip route ecmp load-balance This command is used to configure the hash load balancing algorithm to determine the next hop entry from the different paths to be destined for the same destination. Use the no form of this command to revert to the default setting. ip route ecmp load-balance {{sip | crc32_lower | crc32_upper} | dip | port} no ip route ecmp load-balance [{sip | crc32_lower | crc32_upper} | dip | port] Parameters sip crc32_lower crc32_upper Specifies that the load-balancing algorithm will include the lower 5 bits of the source IP address. This attribution is mutually exclusive with crc32_lower and crc32_upper. If it is set, crc32_lower and crc32_upper will be excluded. Specifies that the load-balancing algorithm will include the lower 5 bits of the CRC. This attribution is mutually exclusive with crc32_upper and sip. If it is set, crc32_upper and sip will be excluded. Specifies that the load-balancing algorithm will include the upper 5 bits of the CRC. This attribution is mutually exclusive with crc32_lower and sip. If it is set, crc32_lower and sip will be excluded. 635