D-Link DGS-3130 Emulator - Page 717

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# ipv6 router rip Switch(config-rtr)# distance 100 Switch(config-rtr)# 69-4 ipv6 rip enable This command is used to enable an IPv6 RIP routing process on an interface. Use the no form of this command to disable an IPv6 RIP routing process on an interface. ipv6 rip enable no ipv6 rip enable Parameters None. Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to enable IPv6 RIP on required interfaces. Example This example shows how to enable the IPv6 RIP routing process on VLAN 1. Switch# configure terminal Switch(config)# interface vlan 1 Switch(config-if)# ipv6 rip enable Switch(config-if)# 69-5 ipv6 rip metric-offset This command is used to set the value to be added to the metric of an IPv6 RIP route received on the configured interface. Use the no form of this command to revert to the default setting. ipv6 rip metric-offset METRIC-VALUE no ipv6 rip metric-offset Parameters METRIC-VALUE Specifies the value to be added to the metric of an IPv6 RIP route received on the configured interface. The valid range is from 1 to 16. 713