D-Link DGS-3130 Emulator - Page 342
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide, NUMBER, DECISECONDS
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 342 highlights
Parameters DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide threshold NUMBER window DECISECONDS (Optional) Specifies the number of frame errors. If the error frames occur in the specified window and exceeds the threshold value, then an error frame event is triggered. The range is 0 to 4294967295. (Optional) Specifies the amount of time over which the threshold is defined. If the threshold frame errors occur within the period, an event notification OAM PDU will be generated with an error frame event TLV, indicating that the threshold has been crossed in this window. The range is 10 to 600 deciseconds. Default The Ethernet OAM error frame event shall be notified by default. The default Ethernet OAM error frame monitor threshold is 1. The default Ethernet OAM error frame monitor window is 10 deciseconds. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The link monitoring function counts the number of error frames detected during the specified window period. This event is generated if the error frame count is equal to or greater than the specified threshold for that period. Example This example shows how to enable notifying an Ethernet OAM error frame event on ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# ethernet oam link-monitor error-frame Switch(config-if)# This example shows how to disable notifying an Ethernet OAM error frame event on ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# no ethernet oam link-monitor error-frame Switch(config-if)# This example shows how to configure ethernet 1/0/1 Ethernet OAM error frame monitor threshold to 100. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# ethernet oam link-monitor error-frame threshold 100 Switch(config-if)# This example shows how to configure ethernet 1/0/1 Ethernet OAM error frame monitor window to 100 deciseconds. 338