D-Link DGS-3130 Emulator - Page 665

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide The configuration of this command can only be attached to a physical port but not a port-channel. That is the minimum guaranteed bandwidth of one CoS cannot be used across physical ports. Example This example shows how to configure the queue bandwidth, the minimum guaranteed bandwidth and maximum bandwidth of queue 1 of ethernet 1/0/1 to 100Kbps and 2000Kbps respectively. Set the minimum guaranteed bandwidth and maximum bandwidth of queue 2 to 10% and 50% respectively. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# queue 1 rate-limit 100 2000 Switch(config-if)# queue 2 rate-limit percent 10 percent 50 Switch(config-if)# 63-19 rate-limit {input | output} This command is used to set the received or transmitted bandwidth limit values for an interface. Use the no form of this command to disable the bandwidth limit. rate-limit {input | output} {NUMBER-KBPS | percent PERCENTAGE} [BURST-SIZE] no rate-limit {input | output} Parameters input output NUMBER-KBPS PERCENTAGE BURST-SIZE Specifies the bandwidth limit for ingress packets. Specifies the bandwidth limit for egress packets. Specifies the number of kilobits per second as the maximum bandwidth limit. Specifies to set the limited rate by percentage. The valid range is 1 to 100. (Optional) Specifies the limit for burst traffic in Kbyte. Default None. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The specified limitation cannot exceed the maximum speed of the specified interface. For the ingress bandwidth limitation, the ingress will send a pause frame or a flow control frame when the received traffic exceeds the limitation. Example This example shows how the maximum bandwidth limits are configured on Ethernet 1/0/5. The ingress bandwidth is limited to 2000Kbps and 4096K bytes for burst traffic. 661