D-Link DGS-3130 Emulator - Page 26

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to display the version information of the Switch. Switch#show version System MAC Address: F0-7D-68-36-30-00 Unit ID ------- 1 Module Name DGS-3130-30TS Versions H/W:A1 Bootloader:1.00.001 Runtime:1.01.001 Switch# 2-16 snmp-server enable traps environment This command is used to enable the power, temperature and fan trap states. Use the no form of this command to disable the state. snmp-server enable traps environment [fan] [power] [temperature] no snmp-server enable traps environment [fan | power | temperature] Parameters fan power temperature (Optional) Specifies to enable the Switch's fan trap state for warning fan events (fan failed or fan recover). (Optional) Specifies to enable the Switch's power trap state for warning power events (power failure or power recovery). This trap can only be sent through 10G ports. (Optional) Specifies to enable the Switch's temperature trap state for warning temperature events (temperature exceeds the thresholds or temperature recover). Default By default, all environment device traps are disabled. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to enable or disable the environment trap states for fan, power and temperature events. If no optional parameter is specified, all of the environment traps are enabled or disabled. Example This example shows how to enable the environment trap status. 22