D-Link DGS-3130 Emulator - Page 697
set metric
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 697 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to configure the IP precedence value to 5 (critical) for packets that pass the route map match. Switch# configure terminal Switch(config)# route-map example permit 10 Switch(config-route-map)# match ip address IPACL_01 Switch(config-route-map)# set ip precedence 5 Switch(config-route-map)# 66-11 set metric This command is used to modify the metric of routes. Use the no form of this command to revert to the default setting. set metric VALUE no set metric Parameters VALUE Specifies the metric of route. The range is from 0 to 4294967294. Default None. Command Mode Route-map Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to modify the metric of routes. Example This example shows how to configure the metric of routes that pass the route map match to 100. Switch# configure terminal Switch(config)# route-map example permit 10 Switch(config-route-map)# match ip address IPACL_01 Switch(config-route-map)# set metric 100 Switch(config-route-map)# 693