D-Link DGS-3130 Emulator - Page 476

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline This command is used to limit the number of IPv6 binding entries on which the IPv6 snooping policy is applied. This command helps to limit the binding table size. Example This example shows how to limit the number of IPv6 snooping binding entries to 25. Switch# configure terminal Switch(config)# ipv6 snooping policy policy1 Switch(config-ipv6-snooping)# limit address-count 25 Switch(config-ipv6-snooping)# 43-4 ipv6 snooping attach-policy This command is used to apply an IPv6 snooping policy to a specified VLAN. Use the no form of this command to remove the binding. ipv6 snooping policy attach-policy POLICY-NAME no ipv6 snooping policy attach-policy Parameters POLICY-NAME Specifies the name of the snooping policy. Default No IPv6 snooping policy is applied. Command Mode VLAN Configuration Mode. Command Default Level Level: 12. Usage Guideline After an IPv6 snooping policy has been created, use this command to apply the policy on a specific VLAN. Example This example shows how to enable IPv6 snooping on VLAN 200. Switch#configure terminal Switch(config)#vlan 200 Switch(config-vlan)#ipv6 snooping attach-policy policy1 Switch(config-vlan)# 472