D-Link DGS-3130 Emulator - Page 910

Parameters VRID INTERVAL DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies the virtual router identifier that identifies the VRRP group. The valid range is from 1 to 255. Specifies the time interval between successive advertisements by the master router. The unit of the interval is in seconds. The valid value is from 1 to 255. Default By default, this value is 1 second. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The maser will constantly send VRRP advertisements to communicate the related information of the current master virtual router. This command configures the interval between advertisement packets and the time before other routers declare the master router as down. All routers in a VRRP group must use the same timer values. Example This example shows how to configure the router to send advertisements for VRRP 7 every 10 seconds on interface VLAN 1. Switch# configure terminal Switch(config)# interface vlan 1 Switch(config-if)# vrrp 7 timers advertise 10 Switch(config-if)# 91-7 vrrp preempt This command is used to allow a router to take over the master role if it has a better priority than the current master. Use the no form of this command to change back to non-preempt mode. vrrp VRID preempt no vrrp VRID preempt Parameters VRID Specifies the virtual router identifier that identifies the VRRP group. The valid range is from 1 to 255. Default By default, the preempt mode is used. Command Mode Interface Configuration Mode. 906