D-Link DGS-3130 Emulator - Page 630

Default None. DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode MST Configuration Mode. Command Default Level Level: 12. Usage Guideline The secondary VLANs need to be mapped to the same MST ID as the primary VLAN if private VLAN is configured. If the mapping is not synchronized when the user exits the MST Configuration Mode, a warning message will be displayed. Use the private-vlan synchronize command to synchronize the MST ID mapping before exiting the MST Configuration Mode. This command will not be saved in the running configuration. Example This example shows how to synchronize the MST mapping before exiting the MST Configuration Mode. Switch# configure terminal Switch(config)# spanning-tree mst configuration Switch(config-mst)# instance 1 vlans 1-100 Switch(config-mst)# instance 2 vlans 101-200 Switch(config-mst)# private-vlan synchronize Switch(config-mst)# 61-4 switchport mode private-vlan This command is used to specify a port as a private VLAN port. The port type can be a host port, promiscuous port, trunk promiscuous port or trunk secondary port. switchport mode private-vlan {host | promiscuous} Parameters host promiscuous Specifies the port as an isolated port or a community port. Specifies the port as a promiscuous port. Default By default, this option is configured as Hybrid VLAN mode. Command Mode Interface Configuration Mode. Command Default Level Level: 12. 626