D-Link DGS-3130 Emulator - Page 329

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 30-11 permit | deny (arp access-list) This command is used to define the ARP permit entry. Use the deny command to define the ARP deny entry. Use the no form of this command to remove an entry {permit | deny} ip {any | host SENDER-IP | SENDER-IP SENDER-IP-MASK} mac {any | host SENDER-MAC | SENDER-MAC SENDER-MAC-MASK} no {permit | deny} ip {any | host SENDER-IP | SENDER-IP SENDER-IP-MASK} mac {any | host SENDERMAC | SENDER-MAC SENDER-MAC-MASK} Parameters ip any host SENDER-IP SENDER-IP SENDER-IPMASK mac any host SENDER-MAC SENDER-MAC SENDERMAC-MASK Specifies the source IP address. Specifies to match any source IP address. Specifies to match a single source IP address. Specifies to match a group of source IP addresses by using a bitmap mask. The bit corresponding to bit value 1 will be checked. The input format is the same as IP address. Specifies the MAC address. Specifies to match any source MAC address. Specifies to match a single source MAC address. Specifies to match a group of source MAC addresses by using a bitmap mask. The bit corresponding to bit value 1 will be checked. The input format is the same as MAC address. Default None. Command Mode ARP Access-list Configuration Mode. Command Default Level Level: 12. Usage Guideline Using the permit any option will permit the rest of the packets that do not match any previous rule. Example This example shows how to configure an ARP access-list with two permit entries. Switch# configure terminal Switch(config)# arp access-list static-arp-list Switch(config-arp-nacl)# permit ip 10.20.0.0 255.255.0.0 mac any Switch(config-arp-nacl)# permit ip 10.30.0.0 255.255.0.0 mac any Switch(config-arp-nacl)# 30-12 show ip arp inspection This command is used to display the status of DAI for a specific range of VLANs. 325