D-Link DGS-3130 Emulator - Page 531
loopback-detection Interface, loopback-detection interval
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 531 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to enable the port-based loopback detection function globally and set the detection mode to port-based. Switch# configure terminal Switch(config)# loopback-detection Switch(config)# loopback-detection mode port-based Switch(config)# 49-2 loopback-detection (Interface) This command is used to enable the loopback detection function for an interface. Use the no form of this command to disable the function for an interface. loopback-detection no loopback-detection Parameters None. Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to enable the loopback detection function on an interface. This command is available for port and port-channel interface configuration. Example This example shows how to enable the loopback detection function on interface ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# loopback-detection Switch(config-if)# 49-3 loopback-detection interval This command is used to configure the timer interval. Use the no form of this command to revert to the default setting. loopback-detection interval SECONDS no loopback-detection interval 527