D-Link DGS-3130 Emulator - Page 124
ip proxy-arp, ip local-proxy-arp
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# interface vlan 100 Switch(config-if)# ip address 10.108.1.27 255.255.255.0 Switch(config-if)# ip address 192.31.7.17 255.255.255.0 secondary Switch(config-if)# ip address 192.31.8.17 255.255.255.0 secondary Switch(config-if)# 9-5 ip proxy-arp This command is used to enable the proxy ARP option for an interface. Use the no form of this command to revert to the default setting. ip proxy-arp no ip proxy-arp Parameters None. Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the proxy ARP state for an interface. When proxy ARP is enabled, the system will respond to ARP requests for IP addresses within the local connected subnets. Proxy ARP can be used in the network where hosts have no default gateway configured. Example This example shows how to enable proxy the ARP feature on the interface of VLAN 100. Switch# configure terminal Switch(config)# interface vlan 100 Switch(config-if)# ip proxy-arp Switch(config-if)# 9-6 ip local-proxy-arp This command is used to enable the local proxy ARP feature on an interface. Use the no form of this command to revert to the default setting. ip local-proxy-arp no ip local-proxy-arp 120
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/124.png)