D-Link DGS-3130 Emulator - Page 706
ip rip send version
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 706 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline Use this command to specify the version of the receive RIP version for an interface. If not specified, the global setting is followed. Example This example shows how to configure the interface (VLAN 1) to accept both RIP version 1 and version 2 packets. Switch# configure terminal Switch(config)# interface vlan 1 Switch(config-if)# ip rip receive version 1 2 Switch(config-if)# 68-7 ip rip send version This command is used to specify a RIP version to send on an interface basis. Use the no form of this command to revert to the default setting. ip rip send version [1 | 2] no ip rip send version Parameters 1 2 (Optional) Specifies to send RIP version 1 packets. (Optional) Specifies to send RIP version 2 packets. Default By default, the global setting will be used. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to specify the send RIP version for an interface. If not specified, the global setting is followed. Example This example shows how to configure the interface VLAN 100 to send RIP version 1 packets. Switch# configure terminal Switch(config)# interface vlan 100 Switch(config-if)# ip rip send version 1 Switch(config-if)# 702