D-Link DGS-3130 Emulator - Page 271

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide ipv6 dhcp relay enable no ipv6 dhcp relay enable Parameters None. Default By default, this option is enabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the state of the DHCPv6 relay function for each port. Example This example shows how to disable the DHCPv6 relay function on port ethernet 1/0/1. Switch#configure terminal Switch(config)#interface ethernet 1/0/1 Switch(config-if)#no ipv6 dhcp relay enable Switch(config-if)# 24-13 ipv6 dhcp relay remote-id profile This command is used to create a new profile for DHCPv6 relay Option 37 and enter the DHCPv6 Profile Configuration mode. Use the no form of this command to remove the profile. ipv6 dhcp relay remote-id profile NAME no ipv6 dhcp relay remote-id profile NAME Parameters NAME Specifies the profile name. The maximum length is 32 characters. The profile can be created up to 6 entries. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. 267